|
Vol.51, No.2, 125 ~ 131, 2013
|
| Title |
| Effect of an Anode Functional Layer on Cell Performance of Anode-Supported Solid Oxide Fuel Cells by a Decalcomania Method |
| 조해란 Hae Ran Ch , 최병현 Byung Hyun Choi , 안용태 Yong Tae An , 구자빈 Ja Bin Koo , 백성현 Sung Hyeon Baeck , 노광철 Kwang Chul Roh , 지미정 Mi Jung Ji , 박선민 Sun Min Park |
|
|
|
| Abstract |
| In this study, we fabricated anode-supported solid oxide fuel cells by the decalcomania method. To investigate the effect of the anode functional layer (AFL) in a cell, AFL decalcomania paper was coated between the electrolyte and the anode support. The results showed that the surface roughness of the electrolyte coated on the anode support was not uniform (Ra = 7.86 nm), but that of electrolyte coated on AFL was uniform. A thin electrolyte layer with very low surface roughness was obtained. Then Ra was 2.65 nm. In this case, while the output power of the cell with the AFL (Cell 2) had an open circuit voltage (OCV) of 1.12 V and a maximum power density (MPD) of 650 mW cm-2 at 800℃, the cell without the AFL layer (Cell 1) had an OCV of 0.9 V and an MPD of 635 mW cm- |
|
|
| Key Words |
| Fuel Cells, coating, electrical properties, scanning electron microscopy, Surface roughness |
|
|
 |
|
